Your shopping cart is empty!
Spiral Distilling Apparatus
Total length: 57cm (22.5 inch)
Spiral length: 27cm (10.5 inch)
Hose connection: Ø 8mm (0.3 inch)
Read the instructions below prior to using the device:
1.The distilling apparatus is made of durable technical
2. It comes with four spouts. Spout A and B are used for
connecting cooling water (see figure). Spout C is used for connecting the
distilling apparatus with the source of vapour. Spout D is the condensed liquid
3. Connect a hose from the cold water faucet to spout A. The
hose connected to spout B should drain the cooling water freely into the sink.
4. Connect spout C with the heated vessel with a hose.
Vapour will get into the distilling apparatus through the hose. Place spout D
above the vessel where you You will collect the condensed liquid.
5. We recommend using high quality silicone hose set to connect the distilling apparatus.
They are resistant to high temperatures and certified for use with food.
How does the distilling apparatus work?
1. The distilling apparatus consists of two tubes. The
external one has the function of a cooler. Water running through the tube is
supposed to ensure a constantly low temperature of the distilling apparatus.
2. Condensing vapour moves along the internal tube. Its
spiral shape increases the cooling area as well as efficiency of the distilling
3. Vapour from the heated vessel gets through spout C into
the internal spiral, where they are subject to condensing and cooling. Next in
a liquid form they will flow through spout D into the vessel for the
NOTE: Remember that
cooling water must flow in the distilling apparatus in the direction contrary
to the distillate flow (see drawing). Always activate the flow of cooling water
first and then start heating the distilled liquid. Not observing this sequence
will cause overheating and breaking the glass. The heating and distilling
process must occur—smoothly. The distillate should flow from spout D drop by drop
or in a form of minor stream. If you observe a decline in the distillate
dripping rate after some time, at unchanged distillation conditions, you can
assume the distillation process has been completed. Dismantle the set only once
it has cooled down. To ensure even and smooth evaporation of the heated liquid
it’s good to add some pieces of China clay or broken ceramics to the liquid.
The distilling apparatus is made of glass. Take special care while using it, use certified gloves
resistant to piercing with glass and wear protective goggles.
Spiral Distilling Apparatus
Total length: 47cm (18.5 inch)
Spiral length: 22cm (8.7 inch)
Spiral Distilling Apparatus made of stainless steelTotal length: 40cm (15.75 inch)Spiral length: 3mt..
Spiral Distilling Apparatus made of stainless steelTotal length: 25cm (9.85 inch)Spiral length: 2mts..
Oak chips are beneficial for introducing premium oak characters to wines at a low cost while offerin..
Turbo Yeast – Coobra T3 BasicFor: 7kg of sugar and 21L of waterFermentation time: 5 daysOp..
Tags: distilling apparatus